10:41. Steering draft
Prevention
At installation it is necessary to use the new fixing plate established on heads of bolts of fastening of steering thirsts for steering transfer. At removal of steering draft together with a steering rod end it is necessary to use a stripper of spherical hinges and new самоконтрящуюся the nut fixing the spherical hinge to a rack of a forward suspension bracket.
Removal
Fastening of steering thirsts for steering transfer
|
|
1 – bolts;
2 – the fixing plate;
3 – plate |
| PERFORMANCE ORDER |
| 1. In the presence take off a wheel cap, then weaken bolts of fastening of a forward wheel. Tighten the emergency brake, then lift a forward part of the car and fix on supports. Remove the corresponding forward wheel. |
| 2. Unscrew самоконтрящуюся the nut fixing the spherical hinge of a tip of steering thirst for a rack of a forward suspension bracket. |
| 3. Using a stripper of spherical hinges, take a pin of the spherical hinge of a tip of steering draft from a rack of a forward suspension bracket. |
| 4. If steering draft is removed without tip, weaken tightening the bolt fixing steering thirst for the carving regulator on a tip. |
| 5. Using a screw-driver edge as the lever, remove the fixing plate from heads of bolts, fixing steering thirsts for steering transfer and unscrew bolts (see the drawing). |
| 6. If steering draft is removed assembled together with steering rod ends, take it from under the car. |
| 7. If steering draft is removed without steering rod end, note paint or an adhesive tape note the provision of a tip on the carving regulator, or count number of rounds of a carving on the acting part of the carving regulator. Unscrew steering draft from a tip and take from under the car. |
|
Installation
Installation is made in the sequence, the return to removal taking into account the next moments...
| PERFORMANCE ORDER |
| 1. On bolts of fastening of steering thirsts for steering transfer it is necessary to establish the new fixing plate. |
| 2. If steering draft is established together with a steering rod end, connect a pin of the spherical hinge of a steering rod end from a resistant forward suspension bracket and fix new самоконтрящейся by a nut, having tightened it the required moment.
|
| 3. If steering draft is established without steering rod end, screw draft in the carving regulator in the same situation, as before removal and tighten tightening a bolt. |
| 4. Lower the car on wheels and tighten bolts of fastening of a wheel. |
| 5. Check and, if necessary, adjust the angles of installation of forward wheels. |
|
Enjoy ad-free streaming with 