10:13. Replacement of the hug bearing of a back wheel (model since 1993)
Prevention
At installation it is necessary to use new nuts of fastening of the fastener of a nave.
Non-demountable knot of a nave and the bearing of a back wheel on late models with ABS
|
|
1 – nave;
2 – nave fastener;
3 – bolt;
4 – a dustproof cap with the ABS sensor;
5 – bearing;
6 – sealing ring
|
Removal
| PERFORMANCE ORDER |
| 1. Since 1993 on all models of an ustanavla the non-demountable knot of a nave and the bearing of a back wheel is howled (see the drawing). |
| 2. As the knot consisting of the fastener of a nave of a nave and the hug bearing is non-demountable knot, adjustment of the bearing is not required. |
| 3. Take off a wheel cap, then weaken bolts of fastening of a wheel. Lift a back part of the car and fix on supports. Remove the corresponding back wheel. |
| 4. Remove a support of a back disk brake. Without disconnecting a brake hose from a support, using a soft wire, tie up a support to a back suspension bracket, at the same time do not stretch and overwind a brake hose. |
| 5. Remove a returnable spring from the lever of a block of the emergency brake and a brake board. |
| 6. Unscrew the screw and remove a brake disk. |
| 7. Disconnect the electric socket from the ABS sensor. |
| 8. Unscrew four nuts and remove nave knot together with a brake board. As soon as there is an access, disconnect a cable of the emergency brake from the lever of a block of the emergency brake. |
|
Installation
Installation is made in the sequence, the return to removal taking into account the next moments...
| PERFORMANCE ORDER |
| 1. Tighten nuts of fastening of knot of a nave the required moment. |
| 2. Check correctness of connection of a cable of the emergency brake and a returnable spring. |
| 3. Establish a brake disk and a support of a brake. |
| 4. Check adjustment of a cable of the emergency brake, then establish a wheel and lower the car on the earth. |
|
