| 1. Using the load-lifting mechanism, install the engine together with the transmission in a motor compartment of the car. |
| 2. Working under the car, establish a back arm of fastening of the transmission. Establish new plates under bolts of fastening of an arm and tighten bolts the required moment. |
| 3. Screw in two bolts fixing a back arm of the transmission to the lower frame, but do not tighten them finally. |
| 4. Establish the right arm of fastening of the power unit and screw bolts on the block of cylinders, having tightened bolts the required moment. |
| 5. Screw in new bolts of fastening of the right arm of the power unit to a body, but do not tighten them finally. |
| 6. Establish the left arm of the power unit and screw it bolts on the transmission, having tightened them the required moment. |
| 7. Screw new bolts the left arm of the transmission on a body and tighten bolts the required moment. |
| 8. Tighten bolts of fastening of the right arm of the power unit to a body and bolts of fastening of a back arm of the transmission to the lower frame the required moment. Unhook captures of the load-lifting mechanism from the engine. |
| 9. Connect the internal ends of power shafts to the transmission (see the corresponding description in section 14). |
| 10. Establish a reception exhaust pipe. |
| 11. Establish a pulley of a bent shaft and fix it by bolts in the sequence, the return to removal. |
| 12. On models with the automatic transmission connect electric sockets to switches, an electromagnet to ny windings and sensors of the transmission. Replace a hose of ventilation of a case of the transmission and the sensor of oxygen. |
| 13. Connect the tire of grounding to the transmission and fix it by a nut. |
| 14. Lower the car on the earth. |
| 15. Connect a cable of the drive of a speedometer to the transmission and fix it by the plug. |
| 16. Connect the electric socket to the switch of lamps of a backing. |
| 17. On models with the mechanical transmission fix a coupling cable cover to a transmission case arm, then connect a cable of coupling with the squeezing lever and adjust it. |
| 18. Install the mechanism of the choice of transfers. |
| 19. Establish a protective cover on a coupling case. |
| 20. Establish coupling. |
| 21. Establish a reception exhaust pipe. |
| 22. Establish a pulley of a bent shaft in the sequence, the return to removal. Tighten a bolt or bolts of fastening of a pulley of a bent shaft the required moment. |
| 23. Lower the car on the earth. |
| 24. In the sequence, to removal establish the return all earlier removed wires, tubes and hoses. |
| 25. In the presence, install the pump of the amplifier of steering, adjust a tension of a driving belt of the pump and remove air from hydraulic system. |
| 26. Install the generator and adjust a tension of a driving belt. |
| 27. Install the case of the air filter. On models with the carburetor establish a branch pipe of supply of the warmed-up air from an inlet collector to the carburetor. |
| 28. Establish a new oil filter and fill in oil in the engine. |
| 29. Establish a radiator and fill in cooling liquid in the cooling system. |
| 30. Establish a cowl. |
| 31. Check oil level in the transmission and, if necessary, add it. |
| 32. On models with the automatic transmission adjust a cable of switching and, if necessary, add transmission liquid. |
| 33. Connect a weight wire to the accumulator. |
