77d7eb28

3.1.19. Back sealing ring of the camshaft

Removal

PERFORMANCE ORDER
1. The back sealing ring of the camshaft can be replaced on the engine installed in the car after removal of the distributor of ignition.
2. Remove the ignition distributor.
3. On l models 1,4 and 1,6 except the C16 NZ2 engine the sealing ring is established in a back part of the case of the distributor of ignition. Using an edge of the thin screw-driver, take an old sealing ring.
4. On the C16 NZ2 models 1,8 and 2,0 of l using an edge of the thin screw-driver, take a sealing ring from the camshaft case.

Installation

PERFORMANCE ORDER
1. On l models 1,4 and 1,6 except C16 NZ2 engines establish a new sealing ring, and then establish to a raspreda a litel of ignition.
2. On the C16 NZ2 models 1,8 and 2,0 of l establish a new sealing ring so that it was up to standard with the case, then establish ignition distributor elements.