| 1. Using a tap of M10x1,25 clear two openings in a body for fastening of the left rubber pillow of the transmission. |
| 2. On models with the automatic transmission if from the hydrotransformer liquid flowed out, fill in it to the maximum level. For an exception of damage of a sealing ring of an entrance shaft of the transmission wipe the plug of the hydrotransformer and install the hydrotransformer so that he correctly united to shaft. |
| 3. If replacement of the transmission was made, clear channels of an additional radiator of cooling of transmission liquid for what it is possible to use compressed air under low pressure, but at the same time be careful not to deform a radiator. |
| 4. Using a tap of M10x1,25 clear a carving in fastening openings гидротран a sformator and prepare new bolts of fastening. |
| 5. Tighten nuts and bolts the required moment. When tightening bolts of fastening of the hydrotransformer to a plate of the drive it is necessary to use the special extender see rice. Use of the special extender for tightening of bolts of fastening of the hydrotransformer). |
| 6. If coupling is screwed by bolts on a flywheel, be careful that the transmission did not freeze up on entrance to a shaft. |
| 7. Install the transmission on the engine and fix by bolts, having tightened them the required moment. |
| 8. Establish a protective cover of a case of coupling. |
