3.1.34. Removal and installation of a bent shaft
Prevention
At installation of covers of bearings of a bent shaft it is necessary to use new bolts.
Tag arrangement on a cover of the radical bearing on the engine of 1,6 l
| PERFORMANCE ORDER |
| 1. Remove the engine from the car. |
| 2. Remove a head of the block of cylinders. |
| 3. Pick up the oil pallet, the maslopriyemny phone of the oil pump and a reflector of oil. |
| 4. Remove the oil pump. |
| 5. Remove a flywheel or a plate of the drive. |
| 6. Remove pistons with rods. |
| 7. Turn the block of cylinders a bent shaft up. |
| 8. Check existence of marking on covers of radical bearings. Covers are numbered by figures from 1 to 4, and the cover No. 1 is located from a gear belt. The back cover of the radical bearing located at a flywheel has no identification tag. Pay attention that numbers of covers are correctly read from the water pump at the turned engine (see the drawing). |
| 9. Unscrew bolts and uncover radical bearings. If radical inserts are reused, fix them with the corresponding covers. |
| 10. On the central radical bearing the half rings defining a side play of a bent shaft are established. |
| 11. Remove a bent shaft from the block of cylinders. |
| 12. Take the top radical inserts from the block of cylinders. If inserts are reused, pro-brands to their ruyta for the subsequent installation on the places. |
| 13. Check a condition of a bent shaft. |
|
