77d7eb28

3.1.28. Replacement of a back sealing ring of a bent shaft

Installation of a new back sealing ring of a bent shaft on the engine of 2,0 l

PERFORMANCE ORDER
1. Remove the engine from the car, and then remove a flywheel or a plate of the drive.
2. Drill two small openings located in the opposite ends of a sealing ring in a sealing ring. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws.
3. Clear a nest for a sealing ring.
4. Dip a new sealing ring into pure engine oil and, using a tubular mandrel of the corresponding diameter, establish a sealing ring in a nest at the level with the surface of the block of cylinders (see rice).