| 1. Clear the interfaced surfaces of the oil pump and the block of cylinders, then install new laying of the oil pump on the block of cylinders (see rice. Installation of new laying of the oil pump on the block of cylinders of the engine of 2,0 l). |
| 2. For protection of working edges condense a telny ring at installation of the oil pump wrap up an adhesive tape a bent shaft. |
| 3. Install the oil pump, at the same time the internal rotor of the pump has to settle down correctly on shestigrann ке a bent shaft. Screw in bolts of fastening of the oil pump and tighten them the required moment. Remove an adhesive tape from a bent shaft (see rice. A hexagon arrangement on cranked to a shaft for the drive of an internal rotor of the oil pump on l engines 1,4 and 1,6, the Arrangement лысок on cranked to a shaft for the drive внутрен it a rotor of the oil pump on l engines 1,8 and 2,0, Tightening of bolts of fastening of the oil pump on a dvigata of le of SOHC of 2 l). |
| 4. If the engine is installed in the car, further installation is made in the sequence, the return to removal. Fill in engine oil in the engine. |
| 5. Connect the electric socket to the oil pressure sensor. |
| 6. On C16 NZ2 engines 1,8 and 2,0 of l establish a new oil filter. |
| 7. Establish a reflector of oil, a masloz a boric pipe of the oil pump and the oil pallet. |
| 8. Establish a back casing of a gear belt, a gear belt and adjust a tension of a gear belt. |
