77d7eb28

6.18. Removal and installation of a starter

Removal

Places of connection of an electrical wiring to the traction relay of a starter

Arrangement of a bolt of fastening of an arm of support of a reception exhaust pipe and starter on models of 1,6 l

Arrangement of bolts of fastening of a starter on model of 1,6 l

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Tighten the emergency brake, then lift a forward part of the car and record on supports.
3. On models with DOHC engines remove the lower protective plate of the engine.
4. Mark, then disconnect an electrical wiring from the traction relay (see rice. Places of connection of an electrical wiring to the traction relay of a starter).
5. In the presence unscrew a bolt, the fixing arm of support of a reception exhaust pipe and a starter to the block of cylinders of the engine (see rice. An arrangement of a bolt of fastening of an arm of support of a reception exhaust pipe and a starter on models of 1,6 l).
6. Unscrew two bolts of fastening of a starter. Keep in mind that the bolt located from the transmission can fix an arm of a plait of wires (see rice. An arrangement of bolts of fastening of a starter on model of 1,6 l).
7. Remove a starter.

Installation

PERFORMANCE ORDER
1. Installation is made in the sequence, the return to removal.
2. Check that the arm of a plait of wires is established into place and tighten fastening bolts the required moment.