12:57. Safety cushion
Prevention
Before work with a safety cushion remove a weight wire from the accumulator. After completion of works check that interior of the car empty and connect a weight wire to the accumulator.
On all models made since 1993 the safety cushion is established. At each inclusion of ignition the control unit of a safety cushion makes self-diagnostics within 4 seconds and at this time the control lamp of a safety cushion on a combination of devices burns. If the control lamp does not light up at inclusion of ignition or is not switched off after self-diagnostics, or burns constantly, so in system of a safety cushion there is a damage and it is necessary to address immediately on service station.
Precautions
When performing any works on the car equipped with the safety airbag during the moving and storage of a safety cushion it is necessary to observe the following precautions:
– not to disconnect the accumulator at the working engine;
– when performing any works on a security system or carrying out electric welding on the car deactivate a security system;
– if the lamp of an emergency tion of a signaliz of a security system burns, it is necessary to address immediately on service station;
– it is necessary to transport the safety airbag separately, a bag up;
– when transporting not to place a hand on a safety cushion;
– not to throw a safety cushion;
– not to sort a safety cushion;
– to exclude hit on a safety cushion of solvents or the clearing substances;
– not to subject a safety cushion to influence of temperature over 90 °C;
– not to allow contact of a safety cushion with an open flame;
– do not install on the car a safety cushion with defects or damages.