12:23. Elements of a control and management system
| PERFORMANCE ORDER |
| 1. Remove a weight wire from the accumulator. |
|
CONTROL LAMPS
Control lamps are located on a combination of devices. Removal and installation of lamps are stated above.
CONTROL UNIT
Removal
| PERFORMANCE ORDER |
| 1. The control unit is located under the dashboard over a ware box. |
| 2. Remove a ware box. |
| 3. Disconnect the electric socket from the block, then release the block from fastenings and take it from interior of the car. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
SENSOR OF LEVEL OF COOLING LIQUID
Removal
| PERFORMANCE ORDER |
| 1. The sensor of level of cooling liquid is built in in a cover of a broad tank. |
| 2. Disconnect the electric socket from the top part of a cover of a broad tank, then unscrew a cover and remove it from a broad tank. |
| 3. In case of malfunction of the sensor replace a cover of a broad tank. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
THE LIQUID LEVEL SENSOR IN THE WINDSCREEN WASHER TANK
Removal
| PERFORMANCE ORDER |
| 1. The sensor is located on a side surface of a tank of windscreen washer. |
| 2. Pump out liquid from a tank of a steklooma of a vatel, then disconnect the electric socket from the sensor and unscrew the sensor. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
SENSOR OF LEVEL OF BRAKE FLUID
Removal and installation of the sensor of level of brake fluid is made in the same way, as well as the sensor of level of cooling liquid.
SENSOR OF LEVEL OF ENGINE OIL
Removal
The sensor of level of engine oil on models with DOHC engines
| PERFORMANCE ORDER |
| 1. Tighten the emergency brake, then lift a forward part of the car and fix on supports. |
| 2. On models with DOHC engines remove an engine mudguard. |
| 3. Disconnect the electric socket from the sensor. |
| 4. Depending on model unscrew three or four bolts fixing the sensor and remove the sensor (see the drawing). |
| 5. Check a condition of a sealing ring of the sensor and, if necessary, replace it. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
| 2. Check the level of engine oil and, if necessary, bring it to norm. |
|
SENSOR OF BURN-OUT OF LAMPS
Removal
| PERFORMANCE ORDER |
| 1. The sensor of burn-out of lamps is located behind the block of safety locks and the relay. |
| 2. Release clamps in the lower part of the block of safety locks and the relay and incline the block forward. |
| 3. Take the sensor from a nest. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
