| 1. For access to nuts of fastening of a bumper remove the back panel of finishing of the luggage compartment for what the screw-driver take percussion caps, then lift the panel for release it from the lower fastenings up (see rice. Removal of the back panel of finishing of a luggage carrier, Arrangement of a nut of fastening of a rear bumper). |
| 2. The bumper is removed assembled with the lower decorative panel of finishing. |
| 3. Remove a weight wire from the accumulator, then remove a lamp of illumination of registration plate from a bumper and disconnect the electric socket. |
| 4. Unscrew nuts of fastening of a bumper. On models with DOHC engines of a nut of fastening of a bumper are available from under the car. |
| 5. In the presence remove special rivets which fix both parties of a bumper to a wheel arch. |
| 6. Remove additional brackets of fastening of a bumper which are from a reverse side of a bumper. |
| 7. From a forward part of a bumper take clamps for what squeeze out from them the central pin. |
| 8. Move each party of a bumper to a back part of the car, then disconnect the ends of a bumper from back wings. |
| 9. Being careful, remove a bumper from a back part of the car, at the same time do not tear an electrical wiring of a lamp of illumination of registration plate. |
