| 1. Purify dust and dirt from a support, and a rust from edge of a brake disk. If blocks are suitable for further operation, clear them, using a wire brush and rags. |
| 2. If new brake shoes are established, press the piston into a support a wooden core or the handle of the hammer. At the same time you watch that the piston did not warp also the surfaces of the piston and a boot were not damaged. At a piston vdviganiye brake fluid is forced out from the brake cylinder in a broad tank therefore constantly watch liquid level in a tank, and if necessary pump out its small amount from a tank. |
| 3. Check that dredging on the piston of a support is located on a vertical axis. If necessary, turn the piston in the correct situation (see rice. A dredging arrangement on the support piston on models with the ventilated disks). |
| 4. Apply a thin film of lubricant for the brake system on the surfaces of brake shoes interfaced to a support. |
| 5. Establish an internal block on a support. At the same time the spring bracket has to be established in dredging of the piston. |
| Establish an external brake shoe. |
| Establish a support with an internal block on the holder of a support. Screw in directing bolts of a support and tighten them the required moment (see rice. Tightening of the directing support bolts on models with the ventilated disk). |
| Establish dustproof caps on the directing support bolts. |
| Establish the fixing spring on a support, at the same time the ends of a spring have to settle down in support openings. |
| In the presence install the new sensor of wear on an internal brake shoe. |
| Similarly replace brake shoes on the second wheel. |
| Establish wheels and lower the car on the earth. Tighten bolts of fastening of a wheel the required moment. |
| Several times press a brake pedal that brake shoes nestled on a brake disk. |
| Check the level of brake fluid in a tank. |
| After installation of new brake shoes avoid sharp braking during the first 160 km of a run of the car. |
