| 1. Purify dust and dirt from a support, and a rust from edge of a brake disk. If blocks are suitable for further operation, clear them, using a wire brush and rags. |
| 2. If new brake shoes are established, press the piston into a support a wooden core or the handle of the hammer. At the same time you watch that the piston did not warp also the surfaces of the piston and a boot were not damaged. At a piston vdviganiye brake fluid is forced out from the brake cylinder in a broad tank therefore constantly watch liquid level in a tank, and if necessary pump out its small amount from a tank. |
| 3. Check that dredging in the piston is located at an angle 23 ° to the horizontal line. If necessary turn the piston in required position. |
| 4. Apply a thin film of lubricant for the brake system on the top and lower end faces of the metal basis of brake shoes. |
| 5. Establish brake shoes in a support. Check that blocks freely move in a support. |
| 6. Establish the spring supporting brake shoes then from the inside implant fingers of fastening of brake shoes. At the same time at the same time press the spring supporting brake shoes. |
| 7. Similarly replace brake shoes on the second wheel. |
| 8. Establish wheels and lower the car on the earth. Tighten bolts of fastening of a wheel the required moment. |
| 9. Several times press a brake pedal that brake shoes nestled on a brake disk. |
| 10. Check the level of brake fluid in a tank. |
| 11. After installation of new brake shoes avoid sharp braking during the first 160 km of a run of the car. |
