9.25. ABS relay (only ABS-2E system)
RELAY OF THE ELECTROMAGNETIC BLOCK AND ENGINE OF THE PUMP
Removal
| PERFORMANCE ORDER |
| 1. The relay of the electromagnetic block and the engine of the pump are established on the hydraulic modulator. |
| 2. Remove a weight wire from the accumulator. |
| 3. Unscrew the screw and remove a plastic cover of the hydraulic modulator. |
| 4. Remove the relay. The smaller relay is a relay of the electromagnetic block, and bigger is a relay of the engine of the pump. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
| 2. Check that the control lamp of ABS dies away after start of the engine. |
|
NOISE-SUPPRESSING RELAY
Removal
Arrangement of the noise-suppressing relay of the ABS system
The noise-suppressing relay is installed in the relay block which is located in the left back part of a motor compartment.
| PERFORMANCE ORDER |
| 1. Remove a weight wire from the accumulator. |
| 2. Uncover the block of the relay and take the noise-suppressing relay (see the drawing). |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is made in the sequence, the return to removal. |
|
