9.29.2. Models with back disk brakes
MODELS WITH THE SOHC ENGINE
Operation on removal of a cable of the emergency brake is similar, as well as for models with back drum brakes with the following differences.
Exclude operations on removal and installation of the brake drum. On these models there is no plate of fastening of a cable of the emergency brake to a brake board, and the end of a cable is connected to a returnable spring.
On models with the catalyst at removal of a long cable of the emergency brake unscrew four nuts and remove the thermofilter of the central section of the exhaust system.
MODELS WITH THE DOHC ENGINE
Fastening of a cable of the emergency brake to a brake shoe on models with DOHC engines
|
|
1 – control lever of the emergency brake;
2 – arm of fastening of a cover of a cable of the emergency brake |
Removal
| PERFORMANCE ORDER |
| 1. On these models the cable of the emergency brake and the compensator are removed assembled. |
| 2. In the presence take off wheel caps, then weaken bolts of fastening of a back wheel. Lift a back part of the car and record on supports. Remove back wheels. |
| 3. Note an arrangement of cables of the emergency brake. |
| 4. On models with the catalyst unscrew four nuts and remove the thermofilter of the central section of the exhaust system. |
| 5. Measure length of the carving draft of the lever of the emergency brake acting from the compensator, then unscrew a nut and disconnect the compensator from draft of the lever of the emergency brake. |
| 6. Disconnect the ends of cables of the emergency brake from control levers of brake shoes and returnable springs (see the drawing). |
| 7. Take a cable of the emergency brake from guides on the bottom of the car and on levers of a back suspension bracket. |
| 8. Remove a cable of the emergency brake together with the compensator. |
|
Installation
Installation is made in the sequence, the return to removal taking into account the next moments...
| PERFORMANCE ORDER |
| 1. For fastening of the compensator to draft of the lever of the emergency brake use a new nut. Screw a nut on carving draft of the lever of the emergency brake on the same distance, as before removal. |
| 2. Check correctness of an arrangement of cables of the emergency brake. |
| 3. Adjust the emergency brake, then establish wheels and lower the car on the earth. |
|
