| 1. Before installation check that the lever of the choice of transfers is installed in situation N, i.e. the third situation from a forward part. Install the switch on a shaft and screw in it against the stop switch cases in a reinforced surface of a shaft. Then tighten a switch clamp / a bulk mouth the required moment. |
| 2. Being careful, tighten the required moment the big nut fixing the switch to a shaft of the lever of the choice of transfers. Record a nut from unscrewing for what bend a short mustache of the fixing plate. |
| 3. For installation of a control lever the transmission on a shaft of the lever of the choice of transfers by flat-nose pliers hold a shaft from a provorachivaniye and tighten a nut the required moment. |
| 4. Establish a pipe for the probe of measurement of level / a bulk mouth with a new sealing ring which needs to be greased for installation simplification. Tighten a nut of fastening of a pipe the required moment. |
| 5. Connect the electric socket and a cable of gear shifting to the switch, then check and, if necessary, adjust a cable. |
