77d7eb28

7.3.17. Sensors of speed of rotation of entrance and output shaft

Removal

PERFORMANCE ORDER
1. Sensors are installed in the top part of a case of the transmission. Sensors can be identified on an arrangement of electric sockets. The electric socket of the sensor of speed of rotation of an entrance shaft is located on the left side of the transmission.
2. Remove a weight wire from the accumulator.
3. Disconnect the electric socket of the sensor.
4. Unscrew the screw of fastening of the sensor and then unscrew the sensor. Close an opening for the sensor a suitable stopper.

Installation

Installation is made in the sequence, the return to removal. At installation of the sensor it is necessary to use a new sealing ring. Tighten the screw of fastening of the sensor the required moment.