| 1. Measure length of a carving tip of a cable of coupling acting from the squeezing lever in a motor compartment. This size needs to be used for ensuring the correct installation of a cable of coupling. |
| 2. Remove the bracket fixing a carving tip of a cable of coupling to the squeezing lever and remove a carving tip from the lever. For simplification of removal move the lever to the engine. |
| 3. In interior of the car remove the lower panel of finishing in deepening for the driver's legs. |
| 4. On the right side of an axis of a pedal of coupling remove the fixing bracket, then unscrew a nut of fastening of a pedal and remove a washer (see rice. Arrangement of a bracket of fixing of an axis of a pedal of coupling). |
| 5. Take a coupling pedal axis from an arm, then lower a pedal and a returnable spring down. Note an arrangement of washers and laying on a coupling pedal axis for their repeated installation on the places. |
| 6. Disconnect a coupling cable from a coupling pedal, release a returnable spring and take a pedal of coupling and a returnable spring from the car (see rice. The elements of a pedal of coupling located as if the pedal of coupling would be in the car, Elements of an axis of fastening of a pedal of coupling). |
