3.2.7. Forward sealing ring of the camshaft
Prevention
At installation of a sealing ring of the camshaft it is necessary to use a new gear belt.
Removal
The forward sealing ring of the camshaft can be replaced on the engine installed in the car.
| PERFORMANCE ORDER |
| 1. Take off a gear belt and the corresponding pulley of the camshaft. |
| 2. Drill two small openings located in the opposite ends of consolidation in a sealing ring. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend a sealing ring for heads of screws. |
| 3. Clear a nest of a sealing ring. |
|
Installation
Installation of a new forward sealing ring to a raspreda of a litelny shaft
| PERFORMANCE ORDER |
| 1. Turn the camshaft in such situation that the adjusting pin was in the top situation, then grease working edges of a new sealing ring with engine oil and establish a sealing ring. For installation of a sealing ring use a tubular mandrel of the corresponding diameter and a big washer and, screwing in a bolt of fastening of a pulley distribute a telny shaft press a sealing ring into a nest (see the drawing). |
| 2. If necessary similarly replace a sealing ring of the second camshaft. |
| 3. Establish pulleys of camshafts and a gear belt. Adjust a tension of a gear belt. |
|
