1. Using a tap of M10x1,25, clear in a body a carving for bolts of fastening of a rubber pillow of the left support of the transmission. |
2. On models with a flat flywheel it is the most convenient to make installation of coupling after installation of the transmission. |
3. Place the transmission under a forward part of the car on a jack with wooden whetstone. |
4. Lift the transmission and screw in the lower bolts of fastening of the transmission to the engine, but do not tighten them finally at this stage. |
5. Establish the left support of the transmission, at the same time for fastening of a rubber pillow to a body use new bolts. Tighten the required moment all bolts of fastening of the left support of the transmission. |
6. Tighten the required moment earlier screwed in bolts of fastening of the transmission to the engine and take a jack from under the transmission. |
7. If acted, establish coupling. Move an entrance shaft of the transmission to a clutch plate nave. |
8. Screw in a bolt in an end face of an entrance shaft of the transmission and establish a new lock ring. |
9. Using new laying, establish a cover in an end face of the transmission and fix by bolts, having tightened them the required moment. Check that the bolt fixing the grounding tire is established on the place. |
10. Install the tire of grounding of the transmission on a bolt and fix by a nut. |
11. Establish and fix by bolts a protective plate on the basis of a coupling case. |
12. Insert the internal ends of power shafts into differential, at the same time use new lock rings. |
13. Establish the lower forward frame. |
14. Establish forward wheels. |
15. Remove the special device for support of the engine. |
16. Lower the car on the earth, then tighten bolts of fastening of a wheel the required moment and, in the presence, establish caps on wheels. |
17. Screw in three top bolts of fastening of the transmission to the engine and tighten them the required moment. |
18. Connect a speedometer drive cable to the transmission and fix it by the adjusting plug. |
19. Connect the electric socket to the switch of lamps of a backing. |
20. Fix a coupling cable cover in an arm on a transmission case, then connect a carving tip of a cable of coupling with the squeezing lever and adjust coupling cable length. Check correctness of an arrangement of a cable of coupling. |
21. Connect a rod of the mechanism of the choice of transfers to draft, then adjust drafts and tighten tightening a bolt. |
22. Check oil level in the transmission and, if necessary, bring it to norm. |
23. Connect a weight wire to the accumulator. |