77d7eb28

8.6. Replacement of covers of hinges of equal angular speeds

Back differential of the all-wheel drive car

Driveshaft of the all-wheel drive car

Back power shaft of all-wheel drive cars
1 – nave;
2 – lock ring;
3 – bearing;
4 – diagonal lever;
5 – flange;		 6 – nut;
7 – a flange with a gear rotor;
8 – external CV JOINT;
9 – power shaft;
10 – internal CV JOINT

PERFORMANCE ORDER
1. Remove a power shaft. Remove the hinge of equal angular speeds from a power shaft. If replacement of two protective covers is necessary, remove only one hinge of equal angular speeds from a power shaft.
2. Remove collars of fastening of a protective cover and shift a protective cover from a power shaft.
3. Clean old lubricant from the hinge of equal angular speeds and fill the hinge with new lubricant.
4. Establish a new protective cover on a power shaft so that the flange of a protective cover was established in a flute of a power shaft.
5. Install the hinge of equal angular speeds with a new lock ring on a power shaft. At the same time the lock ring has to be recorded accurately in a flute of a power shaft.
6. Install a protective cover on the hinge of equal angular speeds, then let out the air from under a protective cover.
7. Fix a protective cover by new collars.
8. Install a power shaft in the car.