1.18. Heating and ventilation
Heating system and ventilation
System of mixing of Opel air
Mixing of cold and hot air allows to regulate temperature without delay and at any speed of the movement to support her practically at the constant level. |
The stream of air depends on the speed of the movement and an obduv. Therefore having blown include even at the movement.
Heater regulators
Left regulator
|
Temperature
|
to the right
|
more warmly
|
to the left |
more cold
|
Lower regulator
|
Gate
|
Left regulator: | |
– on the left |
distribution to forward and back lower space
|
– to the right |
to the top space
|
Right regulator: | |
– on the left |
distribution to the top space |
– to the right |
for defrosting |
Always you hold openings for air opened and close only for a while, for example, at penetration outside of smoke, for this purpose put both regulators on, close all nozzles of an obduv.
The fan of a heater has 4 speeds.
Roller
|
Heater fan
|
About
|
it is switched off
|
whole revolutions
|
Intensity of an air stream increases at turning on of the fan of a heater. For increase in comfort turn on the heater fan also during the movement.
The lattice protecting hit of leaves in salon
The lattice protecting hit of leaves in salon is located in a motor compartment outside of a windshield at the left and on the right and has to be free from leaves and snow. |
Average nozzles of ventilation
Comfortable having blown in the top space the cold or slightly warmed up air it is provided depending on position of the regulator of temperature. |
Both nozzles open by means of a nakatny roller. In situation are closed.
Air flow increases at turning on of the fan of a heater.
The direction of a stream of air is regulated by turn of the rotating part and rotation of lamels.
Side nozzles of ventilation
Through them cold or heated air - depending on position of the regulator moves.
Air flow increases at turning on of the fan of a heater.
Open by means of a nakatny roller. In situation are closed.
The direction of a stream of air is regulated by rotation of lamels.
Ventilation.
Turn temperature regulator to the left, turn on the heater fan.
For the maximum obduv of the top space, install both regulators of heating on, open all nozzles.
For an obduv of the lower space, install the left regulator on.
Air stream to a back seat, average nozzles direct to each other and slightly up.
Heating
• Through nozzles to a windshield and to side glasses.
• To forward and back lower space.
• Through side nozzles of an obduv.
• In any combination.
Productivity of heating depends on temperature of cooling liquid and is established therefore only at the heated-up engine.
For bystry warming up of salon turn temperature regulator to the right and include a stage of an obduv 3.
The mood, health and comfort of passengers highly depend on the correct control of systems of ventilation and heating.
By installation on heating of the lower space and opening on requirement of averages snuffled an obduva it is possible to achieve temperature drop in salon by the principle "the head in cold, and legs in heat".
Heating of the lower space
Turn temperature regulator to the right, include having blown, both regulators of air to the left, close average nozzles of an obduv. |
The warming channels are laid as well to back lower space.
Removal of moisture and hoarfrost from glasses
Move all switches of heating to the right, include having blown; Side nozzles, on requirement for acceleration of defrosting direct to side glasses. |
Heating of back glass, heating of an external mirror
Heating joins only at the working engine. |
The switch near a key of an obduv (a yellow control lamp of inclusion).
Press = it is included
Repeatedly press = it is switched off
Heating is turned off automatically approximately in 15 minutes.
Electric heating of front seats
It is regulated by the thermostat. |
Two switches are located under an ashtray.